Laser Sailboat Manual How Do I Thread The Halyard Of A Laser Sailboat If The Rope Comes Out Completely?

How do I thread the halyard of a laser sailboat if the rope comes out completely? - laser sailboat manual

I work at a summer camp and one of the ships of the line (the rope that pulls the veil) was completely out of the mast. It is a Laser sailboat. ReTHRED need to know how the rope around the mast. Please help, we had donated the boat to us a few weeks ago.

5 comments:

chrisjbs... said...

You must be able to resist the vertical pole to get over it. It is not easy when you have 2 or 3 floors and an open window to have. Or a sailing club with a good performance balconey.
You need to feed on fine wire whip mast weight. The weight can be a few screws, small nuts, or channel swim cap (but only if in small, flexible connections done, instead of) the large loops.
Take the role at the top of the mast, and the weight of more string around the neck. Scroll down until you pass through the exit.
Get a piece of wire with a hook at the end (hook-style) and set the output from the bottom and the hook of the rope through the hole.
Attach the case back to the thread: cloves 2 inches to the case, plus an additional clove hitch by the end of the guide. Wrap a small piece of tape to keep everything.
Drag follow the wire from the top of the mast and the case must.
Make sure a picture of 8 at the end of the leash, or too far!

Kyle M said...

The first is a must-laser, a laser-2. And not only his ReTHRED so hard.

Mike said...

There is a snake that electricians use to pull wire through cables. You'll find it at Home Depot. Its kind of expensive if you just this once

I was prefect online on my pen in my system of reefing and what we did at the end of the beam and a fishing boat, based on the end of a small piece of line and use this line as a "messenger" to the maximum diameter of the to get line.

Good luck!

Mike said...

There is a snake that electricians use to pull wire through cables. You'll find it at Home Depot. Its kind of expensive if you just this once

I was prefect online on my pen in my system of reefing and what we did at the end of the beam and a fishing boat, based on the end of a small piece of line and use this line as a "messenger" to the maximum diameter of the to get line.

Good luck!

David H said...

If there is actually a laser that will not have a case. A laser-sail slides on the mast and the mast is under the pressure of a line running down to the bridge instead.
Other vessels with a line feed normally have a block / pulley at the top of the mast on a leash through.

Post a Comment